Over the past week I've been writing an ALSA driver for an MPEG-4 capture board (4/8/16 channel). What I discovered is there are not many good documents on the basics of writing a simple ALSA driver. So I wanted to share my experience in the hopes that it would help others.
My driver needed to be pretty simple. The encoder produced 8Khz mono G.723-24 ADPCM. So you can avoid the wikepedia trip, that's 3-bits per sample, or 24000 bits per second. The card produced this at a rate of 128 samples per interrupt (48 bytes) for every channel available (you cannot disable each channel).
The card delivered this data in a 32kbyte buffer, split into 32 pages. Each page was written as 48*20 channels, which took up 960 bytes of the 1024 byte page (it could do up to this number, but for my purposes I was only using 4, 8 or 16 channels of encoded data depending on the capabilities of the card).
Now, let's set aside the fact that ALSA does not have a format spec for G.723-24, so my usage entails dumping out the 48 bytes to userspace as unsigned 8-bit PCM (and my userspace application handles the G.723-24 decoding, knowing that it is getting this data).
First, where to start in ALSA. I had to decide how to expose these capture interfaces. I could have exposed a capture device for each channel, but instead I chose to expose one capture interface with a subdevice for each channel. This made programming a bit easier, gave a better overview of the devices as perceived by ALSA, and kept /dev/snd/ less cluttered (especially when you had multiple 16-channel cards installed). It also made programming userspace easier since it kept channels hierarchically under the card/device.
Next post, I'll discuss how the initial ALSA driver is setup and exposed to userspace.